A fella on here ports chainsaws. He has giant fingers like sausages. So, his saw builds get the extra sausages treatment. His avatar has the sausage in it. Lol.
The upgrade kit came yesterday, took saw to work with me last night. I made a gasket to go between the riser and carb from stencil board Barely see it here Top view I did put a thin film of grease, as suggested, on top and bottom of filter... I like the look of the vented trim ,better air flow too... The fit is very nice too... It rips now, will have to tune it in some wood.
It really opens up now, the OEM filter would clog pretty quick, make it run very rich. Have to stop and go clean filter, sometimes before the morning is done. I hope to run it tomorrow and see how it does.
We got chance to run the saw in a knotty post oak log. I think the air filter upgrade is a worthwhile investment, especially when paired with a huskihl build.
Question on the gasket...will the stock one not work at the air horn/carb connection with the kit? Wouldn't be a big deal...made plenty of veggie fiber gaskets previously. Curious. Edit: Is there even one there from factory?
Gotta like that. Chain looks a bit aggressive. My 241 is acting like that currently as I got the rakers a tad to short.
Not on there from factory, the install video suggested a thin film of grease, as he has to block sand the mating surface. It was quite smooth, I just wanted a little insurance
It is a bit aggressive, top face angle is between 50 and 55°, makers were .035 a couple sharpening ago and I'm running 8 pin sprocket. I was also cutting thru some big knots.
