hows you thread

Good afternoon all you how's yous.

 

Here is the sx92 206.00 may go that route lol

 

Nice lineup!!

 

Not bad. Hot out. How's u?

 

Good afternoon fellas.

 

Lounging before work

 

Evidently tired. took a nap. Lol

 

Lol. I may do that shortly. Unloaded trailer full of wood this morning. Going to tear into some saws tonight I hope.

 

Good afternoon here to do just that, think I'll go out and install the crankshaft in that old 272 and start to reassemble. But the snooze felt good! Lol

 

I am hoping to do my first build from the case up soon. Have some 394 cases and a crank to start with. Got one of those tools from mattyo as well.

 

How did you like the tool?

 

394's a dandy of a saw and certainly worth your efforts. I just use heat for assembly, no matter how it's done, as long as the bearings are free you're good to go. Don't be afraid to give the crank a tap if you have to...
Should be free like this when done.

 

Show off lol.

 

Strictly for educational purposes, I can assure you.

 

Lmao it's nice when they spin like that for sure. It took me awhile to get the 266 to that point. A few friendly taps were needed lol.

 

Anyone have a 066 OEM piston laying around? Base was only out .003. All in all it looks ok. I have no clue how many tanks are on the setup.

 

What's the jug look like?








And good evening. How's y'all?

 

Sorry just used my last oem piston, 120.00 on ebay now, dang stihls

 

Dallas might have one hoarded.

 

Evening guys how's everyone

I sent mine to rattler for nick to put in his saw I'm almost out of spares I need to load up again