Funneling suggestions

Sand and wax in the P68 no problems with Matra's , T&D stickies different story so I will be sanding and waxing the P43 this weekend and it should do fine with a mix of Okie's and T&D. With that said what I will be doing for next year as my life with work is too crazy is adding a hopper extension to the P43 for one the funneling as its much worse than the P68 but also extending the burn time so I can run the P43 harder .
Thanks everyone for their experiences and replies .

 

I've come up with a method to not get the 802's to funnel (so far) with less work than mixing another brand together with the 802. I have been using a few bags of 802 then a bag or two of Lacrete then back to the 802. So far thats working out well and the hopper is emptying.

 

This is what I use in my hoppers.

SLIP PLATE Dry Film Lubricant, -75°F to 400 Degrees F, Graphite, 12 oz. Aerosol Can - 1WVK7|33203G - Grainger

 

Thanks Z may have to give it a go !

 

Make sure the stove is stone cold when applying this as the fumes could ignite like a fireball in the hopper

 

Do tell.....

 

I may know "someone" that singed some eyebrows last year when the burn-pot wasn't as cold as they thought it was and the auger shaft was empty

 

Hmmm....I "may" also know someone that had a very, very similar situation happen to with teflon spray in the hopper

 

They say it gets your attention real quick when the hopper becomes a fast moving fireball

 

It's definitely an attention getter!!!!!!!!

 

poooooooooooooooooooook

 

I think I might have had a similar experience.

 

Yes agreed but also just noticed its rated up to 400* F my stove gets up to 500*+ when its single digits or minus out .....

 

The stove body yes, but not the hopper.

 

Plus its the fumes during application that are the real issue.