True....changeout programs usually DO NOT allow for self installs.
15'
Or, call another dealer and simply be honest. Why complicate matters?
Inspect your install? Why? As long as you follow the manual, you won't void the warranty. Oh, and I AM a dealer.
Not necessarily. When you figure an intake thimble is over $200, and most pipe only sets can easily be a couple hundred bucks, that only leaves a...
That would be the first one I have seen leak. It's a welded seam, so, is a weld leaking? If so, bring it back to the retailer and get a new one.
Kinda the same with me......hard to add much to what Krooser said.
*big sigh*......duravent = leaks and callbacks, having to seal joints, tees, elbows. ICC. They even make a bolt on Harman adapter, which connects...
Probably best to visually inspect the board for the settings. The first three switches change ignition feed timing, so those are...
Can't comment on this, not at work, and I don't have the switch settings memorized, but that's a very early Accentra Insert.....black wire probe...
Can't comment on Enviro units. I don't feel it's worth the money to replace a working board for a new one with a greater variability range than...
If I HAD to pick a part, I would go for a combustion motor, and new impeller. I feel there is a higher overall incidence of failure there. The...
why would you replace parts that arent broken?
ALL draft readings are negative. If youre seeing positive readings, your stove isnt feeding....the vac switch kills the pwer to the igniter and...
yea, Cork, it does sound like you have done pretty much everything right, far as I can tell. You could always pull the auger out for fun and look...
possibly by monkeying around with the feeder weldment cover you fixed it? If its leaking air (?) it can break vacuum, causing your feeder not to...
so, a couple things.....with a high draft, its likely you are losing heat up the chimney. When its burning lousy, whats the ESP reading on your...
So, you haven't adjusted low draft downwards then, right? (if you did, the low draft would be reading a reduction in voltage of the combustion...
00000000 all off on the board is correct for that model stove.......be forewarned, you wont find that board again, and the new board WILL NOT have...
ooooh....an old B revision board.....let me check out the settings for the Advance for that board and get back to you.....all your switches are...
