If you want to stay with Husky. My pick would be a 346xp either oe @46cc or ne@5occ or maybe a 550xp.
[ATTACH] This is the largest I have had in awhile .
[ATTACH] I get a load or three every year. I got one a few years ago that was 14" dbh. I enjoyed that one.
I have never been there , but I have seen pictures of it. I have a nephew that goes every year .
Is that in your back yard?
[ATTACH] It took a little longer than I expected, but I finally got a pic. I use the vise to hold the saw when I need to sharpen a chain.
No choke on this one, just the primer. It is better with full synthetic oil and a new plug. The "easy start" Champion was anything but, I also...
Quite a bit of my splitting is not at home, so I needed something a little more portable. I am contemplating a shed to cram it in for winter. That...
[ATTACH] You can't see the table I built. If I get back in time tomorrow I will take a picture . the umbrella will work both horizontal and...
If memory serves to turn low carbon (.08%) steel blue it has to get to around 500° F. I cannot fathom a saw bar getting close to that, even...
It has been a couple of years since I took the metallurgy course and I haven't used any of it since I took it. It was a mandatory course for my...
[ATTACH] If you look at the two blue lines they are very even. I have had this bar since new and I know it has never been hot enough that I...
The blue you see is from the induction hardening process the manufacture uses to keep wear down. To turn steel blue it has to get to +- 600° F...
I will add, never use starting fluid on a two stroke. There is nowhere near enough oil to lubricate the top and bottom ends. Dribble a little mix...
Check Your pm's
Atf and acetone is amazing, I gave my can of Kroil to a friend. If it doesn't work try molasses and water .
I want to say it is Carlton chain, which is made by the same parent company as Oregon.
I cannot speak for the 330, but I have a cs3400 that I have quite a bit of time on. I modded the muffler and have run the snot out of it. It may...
I agree with the "looking like plumbing fittings" and the "GET RID OF THEM" Black iron and galvanized are rated for +- 350 psi. when they let go...
<iframe width="420" height="315" src="https://www.youtube.com/embed/PFtWDpLzfDs" frameborder="0" allowfullscreen></iframe> More carnage.
