This old thing? :whistle: [MEDIA] This is more or less how to do it on a bone stock saw, with known factory specs, with a tach. But you can...
How recent is the China thing? Gators have been Horicon Works (Wisconsin) since day 1. I don't think I care much for the XUV 500 series vs their...
Mule has been around longer. 1989 I believe, the original Gator's were 1992. There was the AMT600/622/626 before that, and if you think an old...
CanAm was in early too. Two passengers, itty bitty bed, meant to GO. Rotax power!
Probably more than once too. We used to take a case like this and give it 15 minutes. If we weren't 100% sure of the problem and the fix in 15...
:rofl: :lol:
If you haven't already - get a 346XP muffler bracket and install it on that 350 to prevent the muffler studs from destroying the cylinder.
When you bore a 4-stroke, that's all you're changing, the compression system. When you change/modify pistons or cylinders in a piston-ported...
He's probably not 100% wrong. By the time you pay 2 hours of shop labor, is it worth it vs replacing a $250 saw that's 10+ years old? Even just...
I wouldn't bat an eye with that powertrain. As long as reverse is good, she's good to go. What's the difference between a big block and a small...
That "four-stroking" sound at wide-open throttle is tough to pick out (as a novice) unless you have someone to demonstrate it in front of you....
Even then, the limiter will mess with the reading on most tachometers. On a limited saw, I like to set the H rich so it takes a lot of load for...
Yes and no. They don't run as smooth, that's for sure. Aggressive as h*** though. And while they aren't always perfect, the square-grind (RSLK...
Maybe I should have invested in more Toby Keith CD's ..... :rofl: :lol::picard: Original condition OBS Chevy's in that good of condition are a...
(Homer Simpson voice) mmmm Klassic cutter design.... mmmmmm :saw:
But is that actually necessary on an engine that has a plated cylinder bore? The surface finish of a new nikasil plated cylinder for a saw, bike,...
That's what is good about these systems vs automotive EFI. They make few assumptions about fuel quality and supporting equipment. They simply...
That inflation thing.... $400 today is worth what $300 was 2-3 years ago. :zip: I remember when they were $279.00.
I'm a member of the MS250 fan club. Thing has been around since the 80's as the 025 and it's still one of the best saws available for around $300....
The actual pressure result is pretty unique to the saw engine and it's design. A little saw is quite capable of pumping up a compression tester...
