Bumper strips, guide strips, bumpers.
Take a close up pic of that valve. It’s possible that it doesn’t have an auto return. If it does, it could be adjusted as mentioned above. I...
Ok. Lots to think about with this one. Do you know much about the fireplace? How’s the chimney?
Check the muffler screen first then go through the fuel system. If the air filter is clean and compression is good, it should run.
Yikes! Good advice for sure. That x-ray pic says it all.
Ask.
WD-40 also works and may be safer. Spray under the clutch cover, too. The saw will load up and die if there’s a bad enough seal leak.
Don’t use the aftermarket lines or filters. Without a proper diagnosis you may be throwing parts at it. Try to tune that carb, first. If you’re...
The link says MSNBC, the article itself is unlikely to have journalistic origins.
The general ignorance surrounding Lyme disease still seems pervasive. After Steere and others figured this crap out, many doctors haven’t kept up...
Yep, I was the 21st case in my county three years ago. It was not fun...
Still heavy when dry, yep. I’ve had it 5 years in the stacks... still heavy even with the borer holes.
This thread needs some cleaning.
They’re good saws. Air filters are usually toasted on heavily used ones... oem is the best for filters, fuel line, etc. The oil leak could be...
Yep, agreed. You learning how to do this will give you skills and confidence for future endeavors. Not many saw geeks want to admit this, but...
Bearing removal- lots of ways to do this but anything forceful can bias them and put stresses on cages. For bad bearings on shafts- I make a...
Gotcha, yes- I was wondering if you drove the seals in but it sounds like you just stabilized them with the socket. While I have a couple...
It died in the cut? Take your muffler off and see if your piston is ok. Start there, then go through the fuel system.
Would this problem only happen with your brake on? OP- fuel system, that line is prone to cracks. As mentioned above check spark...
OEM piston pin bearing?
