[MEDIA] You will need something like this. When my B&S dies it will get a horizontal shaft Honda clone of some sort. I dont care for the pump...
Shaking? He needs a surgeon,as he more than likely ripped it clean off.
Is that antenna on the saw for the headphones?
Out of the rods listed 6011, 6013 and 7018ac will work best on that welder.
[MEDIA] Sass with Jeff Healey:dex:
6011 isn't bad, it's running 6010 on ac current that is splattery.
I have run 6010 on ac also, it is messy. I don't think that it would be any fun in 4g/f.
I don't think he will have much fun if he uses 6010 with that welder. That 7018 wont be much fun unless it has the ac after it also. 6013 gets a...
[ATTACH]
I had the same box. It is an ac only welder. It welds pretty well for an ac welder. It wants 50 amps input @ 230 amps output (rarely ever need...
Many years ago I hand a crapsman tractor, I put a bucket seat from a Vega on it. Drill a couple of holes and some wood shims to level it and...
Pull the muffler and check the piston.
Good saws, they had a good following up here. That one has a brake flag, so it should have a brake. Mike Acers site says 1979.
Chip clearance.
429 per kwh This is a new one on me. Husqvarna 572 XP Chainsaw | OPE Reviews
I run 32:1 in everything. My break in goes something like this, tune a bit rich and run it like I stole it. after a few tanks, tune it like it...
It took about 5 years, but that logo finally fell off, now I can see it lots better. :dex:
[ATTACH] I have used one of these for years. It doesn't care what size of bottle you are pouring from.
I almost hit one a few years ago. I was driving along and out of nowhere an adult eagle missed my windshield by a couple of feet, it flared up...
