I’m thinking I have a problem with the burn pot and BurnPot gasket. On the back wall of my stove the top bolt on the left side has a really weird...
The other thing is it finally lit but it’s pushing pellets over partially burned. I really think I have some kind of air flow problem. Is it hard...
hey guys I know what the 5 blink light means but the thing is there was no pellets in the burn pot and there was no way the igniter could light...
I had to manually light it again and it’s almost like the hot pellets aren’t lighting at the bottom and are getting up near the edge and then...
I also noticed right underneath the burn pot just above the cover for the combustion fan the stove is buldged out a little like it’s warped. Idk...
I put it in the way the stock one was set up. I just cleaned the stove, cleaned the holes and that’s my flame. Something is up
It didn’t time out but the pellets would have overflowed and from what I can see it’s feeding correctly
Ok guys, another problem arose. The stove ran out of pellets last night. Woke up this morning and it was 57 in my House. Loaded it up with some...
I also just remembered that whole wall has a thick “skim” coat of spackle to try and make the wall more even because we knew we weren’t going to...
Just found this.
I have ceramic tile on concrete board with a 1 1/2 air gap between the concrete board and the actual sheet rock. The lower elbow isn’t rusted it’s...
It’s been like that since I bought it. I have a slab house and it’s the only way I can put it. This way it faces the living room and I have a fan...
If you look in the pic at the thimble that is a black cap over it to reduce it to fit the 3” pipe
The thimble was originally for a wood stove so I had to put a reduced from the original prob 6-8” down to a 3”
My exhaust set up is a 90 out of the stove, a 6-7 foot piece of 3” double walled to another 90 then to the thimble which has a reducer to 3” then...
But I used gel to light it.
That’s my normal flame. I can’t send a video for some reason
So do you think the burn pot weldment is bad? I have never had those burn marks on the back before
I had the door open to take the best pic. It’s in cooldown mode right now
I think I might actually have a bad burn pot or burn pot gasket. I don’t know why else I would’ve getting that kind of weird burn pattern on the...
