Battery doesn’t rhyme with steel?
The RM definitely is no where close to that fast! Headed out later today to time the RM. What I said above was unclear, the RM is definitely...
Haven’t had the opportunity to run it that much, but the big ash trunks look like warm butter these days! I’ve only put about 1.25 tanks through...
The RM 28t showed up yesterday, finished up assembly today. I always forget pictures, but I’ll grab some tomorrow when splitting... if I remember!...
I use the Protos, and it is the least bothersome and most helpful piece of safety equipment that I use.
Order was super easy via RM website. Eastonmade is at July 2022 to start production of the next orders, as of last week. Wolfe ridge is 7 months...
If you want a box wedge, I’d go with a Wolfe Ridge or Eastonmade. The floating lift table is nice to have. I ended up with a 28t RM, ordered...
I drive a diesel :doh:
I have a Woodstock Ideal Steel in my shop with double wall for 12ft and then stainless insulated double wall for another 9ft. It burns really...
Wow. That looks like it could be replaced by something much better pretty easily though.
Alright Jeff! Persistence pays off! Setup looks great! :salute:
This is concerning, but my equally rated county line is just a single wedge so I’ve never been able to stall it. Cuts through the gnarliest knots...
I run e-free with triple dose marine stabil in my boat. Pull straight gas from it into a 5 gallon can for the mower, splitter, side by side, etc....
15hp comes short of covering the power needed to flow 22gpm at 2500psi. That flow at 2500psi would need 32.1hp. The 28t actually seems like a...
I used the calculators on that site, and even using the OD of the cylinders the numbers don’t work out for the cycle times and flow rates listed...
28t has a 4.5” cylinder, with a 3” rod, the 37t has a 5” cylinder with a 3.5” rod. Same pump. I’m guessing Paul’s commission goes up a tiny bit...
That would be pretty neat! The EM and TW commercial box wedges are expensive, plus they are not available for months or years anyhow. So your...
Sometimes I pop the splits and then hand the whole thing to my wife to deal with the fibers :rofl: :lol:
That’s nearly as fast as me with a single wedge hydraulic with 10s cycle time! You are crazy.
I have the exact same splitter, and I do 1/4 to 1/3 cord an hour without stacking. I’m pulling rounds from a pile, so that can take a few moments...
