The box is capped and attached to a stud. The only reason I left it in the wall is so I can add the outlet back. The plan is to cut a section of...
In the thread that says "Woodstock ideal steel install". The chimney is a above the peak of the roof by a little over 2' now.
Tile is being laid now that extends 19" on the floor. Pictures are not of the completed project, just progress so far. Drywall, trim, tile...lot...
I added 2' to the top and a roof support [ATTACH]
I'm working on the brace now. It has a roof support and a support into brick halfway up. At this point if it failed it couldn't fall anyway since...
It was the end of a circuit so it is now capped off in a junction box behind the wall.
Thanks everyone. Now that I've had a little fire I have the drive to get the tile finished, drywall patched and trim installed. I can't wait...
Yes. It still wasn't cheap. 8" bit wasn't big enough and the 10" bit added to the cost. Total was $220 doing it myself. Not sure what hiring...
The upstairs is 1188 and the basement is full but only half finished. We keep the doors shut to the unfinished half. Technically we are heating...
Selkirk supervent from menards
A lot more work to go but I couldn't resist a little stinky break-in fire [ATTACH]
Ive been working on the install but I haven't had a ton of time to devote to it. I was finally able to get a small break-in fire going but there...
In Ohio I have heard people call beech trees "ironwood". Seems like a hornbeam or beech would be the same or very similar.
The hole was 10" and the outside of the pipe is 8". I had plenty of wiggle room to tilt it up
Got the hole cored out today. I mounted the outside support with 4- 5/16" sleeve fasteners. I can't imagine that wouldn't be enough to hold 15'...
The manual only shows it assembled the opposite way I have it pictured.
When my chimney exits the basement wall I will have a few inches clearance to the dirt level. I do plan to dig out some, but the side of the...
Around Christmas Cabelas usually does free shipping with a code you out in at checkout. Keep an eye out for that
[ATTACH] I was at Costco today and prime packer briskets were $2.69 per pound. That's the best I've seen here. 20 cents lower than our usual....
Had an insert in my last house. I'm installing a freestanding in my current house. I'm just not thrilled with fans used on inserts. They're noisy...
