I got that inclination from a friend today. Looks like I need a puller to remove the fly? Piston seems tdc when the mag swipes the coil. I...
Anyone have any input on those ohm readings?
Took ohm readings on the coil. 1.56k between plug boot and core and 1.64k between plug boot and cutout terminal and 83 (NOT K) between core and...
I did put a new NGK plug in already. As far as compression, it is very hard to to pull with the decomp off. It was running strong until the...
I pulled the spark plug and let it ground to the cylinder as I looked for spark. No spark visible until I pulled with speed. Then I could see...
I did not have the plug grounded. It isn't truly grounded in the saw though?? Bought new NGK plugs which I prefer and were in the saw from...
Looks like the wiring is good. Keep in mind this was not an instant failure. It took a few minutes to get to non-running state.
No start or ignition at all when I tried to kick it over cold. Took the plug out and shut the lights off to try and see spark. No luck. No sure...
My cutting was on a monster White Oak when this happened. Close operations to milling as it took a tank of fuel for every 3 rounds. Before I...
When I mentioned it burped, I was referring to an attempt to run with an ignition. When it started to act up it would run fine when revved up. I...
Did my Muzzleloader deer yesterday morning. Actually had pulled all the hind quarter meat, straps and front shoulders off earlier in the week....
Ran it for a good 90 minutes after not using if for the last month. Finishing the 4th tank of fuel when I notice the idle is getting low. Have...
This is a paved driveway. It is all base, no topcoat. Done that way for better strength since my truck is usually running 8k or better.
I need to seal my driveway for the first time since it was put down. I have no idea what to use so I appreciate any input. Drive is about 3k sq ft.
I am a dealer for Cuddeback now due to a new technology introduced last year. It is a secure camera for situations like yours. Cameras can send...
There is a signal strength display to assist in that. Surely at greater distances the signal will be reduced. They are better than anything else...
This is a 80/20 review/classified post just for clarification. I have been checking into the Cuddeback Cuddelink tech for a few months now and...
I had the mechanical thumb installed on mine. Great for wood loading/moving. Also helps pick up piles of debris/limbs. That the BH77 hoe?
Keep your eyes on the backhoe pins once that is attached. My unit keeps walking out one of the quick detach pins. There is one in the yard...
Congrats on a purchase you won't regret. I have the L3200 which I thought was the smallest L available? 2013 model. I bought the quick detach...
