Burning stove chow, FSU and blazers. They are all stored inside in my garage b
I mean they also have eagle valley and north country softies but from what I read they aren’t to impressive
im looking to get 2 tons of pellets and my local high end supplier has lacretes for $300, awf ultra premium white pine $300, oakie platinum $320...
Yeah it flaps pretty good and I actually modified a tip for the vacuum with a hose that I can lift the flap and slide the hose in to clean the...
Had it new since 2012, just started doing it like 2 months ago. It’s pulling air from the inside of the house and the set up is a adjustable 90...
Nevermind just read up on it
I also just noticed that when I put it in stove temp the distribution blower wasn’t coming on. I had it in manual ignition. As soon as I flipped...
I mean pellets are getting hot enough to where when I take them out they hurt my hand because they are hot
Put it back to stock setting and this was after about 7 min. Not even a flicker or smoke signal. Opened the door and took pellets out and they...
I have this which says it’s +21 stock. Idk if this is right or not
It’s different first 3 for the p43 right? Do you think I should try subtracting more time off? Mine seems to add to much pellets. Idk why but
I have an old board. My stove is a 2012 so idk what series it is
I did order 2 burn pot gaskets. Waiting on them to be delivered. I did put the first 3 switched to off, off, on which should feed for 21 seconds...
I’m going to try and do a draft test this weekend. The duo switches are actually set up to feed 20 seconds less then stock
I did that. It was feeding pellets to where they would go over the edge. Some of the pellets were hot and partially blackened but not burnt. Even...
I did replace the igniter like 2-3 weeks ago with a stock Harman and new cradle. I siliconed the hoses in the back and where the igniter wires go...
Well I ordered a new burn pot, 2 burn pot gaskets, exhaust gasket and glass gasket. I gave my stove a good cleaning today and took all the pellets...
But why would the flame be protruding from that area if the flame tamer is over it?
Any place you recommend to buy parts from?
I didn’t think of that. That was the first time that ever happened. Remember on the one post I put before about the warp at the back of the stove?...