If your house allows it and you’re handy, you have a nice situation for running two stoves. Keep the basement stove and search Craigslist for...
Is that the Brave Wood General? First failure I’ve seen there from Brave/Iron and Oak products. Usually it’s a wedge/ram area problem.
I’m not a fan of the channel design for those reasons. My Iron and Oak has a bolt push plate on the ram. The main beam has some wear, but it’s...
If it’s a 6400, I’d be ok with $200 with a bar and chain. Seems low, but that’s what they go for used around here. Also- see if the owner lets...
Interesting... Like said above, climate has a lot to do with it. My pole barn sweats when the temps swing, but not to where there’s water...
For the most part, yes. There are flippy caps for trimmers and smaller units that are smaller, I think. Part numbers correspond for your 290 and 460.
Check the entire system again for leaks. Make sure the engine is running properly and can throttle up/down. Work the valve with no load and see...
We have a few Dunstan Hybrids and Chinese Chestnut around WNY. The true American are probably only stump sprouts or misidentified. We...
Yes to muffler bolts or possibly a piece of the baffle if it’s an aftermarket muffler. Use blue Loctite when installing. The spike screw- so...
The newer HD2 knockoffs don’t always have the foam gasket that the first generation had. Pre-2014ish knockoffs were very good. The recent ones...
$500 would be nice. Sitting for 3 years? May need carb kit ($20ish), 1128 oem line ($15ish), 1128 oem impulse ($10ish). If he lets you, wiggle...
Older design, no springs. As mentioned above, the ignition systems can be problematic. They’re heavy, but powerful. Some guys around here still...
The bottom end question depends on a ton of factors. “Hours” just being one. I will say that 1122 series saws are usually used hard by pros or...