I just wanted to pray for everyone on the FHC, stay grounded/humble during the holidays.
Here's a guy on another forum that converts oil furnaces to burn waste motor oil [MEDIA] [MEDIA] This requires filtered oil and better yet if...
Yes sir I am, need to get a bigger truck and use one of the trailers. I think I'm at the point that I just want to winch the pieces/rounds up a...
Few more!
Second load of Elm today.
Yes this oil will need to be filtered, the pump would transfer it to another container higher up in the shop for gravity filtering.
I have a 300 gallon waste motor oil tote on the side of the shop. I'm always thinking about a waste oil furnace although the Fisher stove works...
I hope we all can stay in the same state as we all grow up.
I really like making breakfast and my wife appreciate's it too. :) just two drinks each.
We had a few of these last night so I'm making a late breakfast.
Sweet computer!
Our youngest daughter and husband were living with us until they saved enough for a house. They closed on the house three weeks ago. I can't...
I'll have to check when I get to the shop. So far the hot rod works and the draft infuser fan.:) Here's the new controller.
I watched a Youtube pizza vid where they were using a stone in the outdoor oven, not sure why as the over is usually made from stone/brick?
Using ohms law the 1.4 ohm reading on the auger motor equals a 84 amp draw. :( It's crispy on the outside and I ordered a new one last night....
Shrinkage. :)
Sorry for my confusion, I was wrong to stray from the FHC.......:rolleyes: I'm not worthy...
Trying to see if someone on the fhc is a member on Pellet head forum to check on a log in issue.
Multimeter findings this morning after replacing the fuse and it blowing again. Auger drive, 1.4 ohms Fan 35.5 Hot rod 72.9
I registered earlier this week but no administration approval yet, anyone from the FHC that can send a mod a pm?