Chupi is a hairless breed. She does have a very fine, short down like cover, but no hair. NO FUR BALLS EITHER :thumbs: Her big deal is wiggling...
I am thinking that this entire scenario is the reason I went with the direct vent systems. :whistle: Tall chimneys are fine but not being able to...
We had two of those beasts in the past A cast iron one and the BIG BEAST. YUP If the gaskets are not good the house smells like smoke and they...
When we installed the Big Whit we did not have any worries. Grand kids were very tiny and no critters. We adopted a lovely Sphynx cat a bit over...
Stoves running 24 hours at present and the shack is comfy. Buckets full of shell sit by the stove, ready to give their warmth :thumbs:
The air flow, baffle type and location, the size, type and speed of the draft fan all make a big difference in the amount of crap that collects in...
Just Chillin. Worked a bit on the ADV 2 T control box, took a very hot leisure soak in the tub, had lunch (left over steak) and just doing the...
Got some good progress done today. Holes cut for the two volt meters (Comb and Conv fan speed) Got the layout done for the various switches and...
Summer time air conditioner ??????????????????/
Fired the big Whit this morning while we were getting ready to head out, and within 15 minutes it was out. Hmmmmm, fired it again and watched...
I did not use oaks on any of our units simply because we have a passive air inlet from the roof to the furnace. This allows a change of air in...
Not a bad thought, but these frame style motors just don't really have a way to effectively reject heat. They are a solid little chunk with...
Yup, Probably not to burn them better, but to clear the pot of the crap left behind. When the big Whit is clean and up on the step the air flow...
I have wanted to go on one LAST sled ride, but GOOD sense has prevailed. One good jolt to my lower back is all it would take to really mess me up...
Is there room in the cabinet to install a heat isolating coupler??? If the heat transfer can be reduced the issue might well be lessened.
I need something like that on my little Whit P2 No room to install it though. Chassis is far too tiny to allow any extra equipment in there.
We had our big snow in 08 About 4 feet on the level here at the ranch. Temps near 10 F Hope the best for Y'all
Ordered up another 150 V panel meter for the project. Going to locate the two meters on opposite sides of the panel with the left side meter...
I used to fool with sleds back when I was young and lovely. First sled was a 1969 Rupp Rebuilt that iron horse and then moved on to a new (Then)...
Stoves all "Mucked and Sucked" Widdle one lit and Da big one laid and ready to go. :D:D:D
