The gasket set was from Carb Tech Solution. I don't see it listed on their site though. TK / Bing / Ruixing / Nikki
5/16 grade 70 has a WLL of 4700lbs 3/8 grade 43 has a WLL of 5400lbs There is not a whole lot of difference between the two. Why not use the...
Why does Lowes sell 3/8 grade 43 chain as loggers chain? Why not use 5/16 grade 70?
[IMG]
Not yet. I gotta get a holder for the 4 way wedge then I may add a hatchet holder and a sappie holder. I would also like to to have a place put a...
Here is the contents of the tool box. The tape measure was free at HF and so were the screwdrivers. The locking pliers are from HF and so is the...
The pump should bolt to the engine. He may have to drill new holes to bolt the eninge to the splitter.
Thanks, I have had it in the woods. I'll get a pic of what is the box.
Here is my toolbox holder. I did not have the bungee cord on in the pic. The tool box is an ammo can from HF. [IMG]
I think it is a 455 Rancher[emoji23] No, really I think it is a 346.
I bought an 026 that has cheap top end kit on it. It runs just as good as my 024S with a Hyway M260 top end. I'm not sure how long the cheap top...
You might want to write a contract even though you will be cutting for free and include that they will dispose of the brush and deal with the...
I think it sounds good. Now if you want to fine tune it you can make small adjustments and time your cuts to find where the saw performs the best.
Try tooning a saw with a full tank and see what happens.
You probably want it to turn around 14,000rpm out of the wood.
Madsens says to tune them at a half tank. If you tune them with a full tank they will be lean at an emtpy tank, and if you tune them with an empty...
It sounds too rich. The saw should cleanup in the cut and it is not turning enough RPM's out of the cut.
That is cool it will be interesting to see how accurate it is.
The people here call them a tie pick.
I checked my MM against an ohm meter and it looks like my MM is with in 10%.
