USPS shipping charges are calculated from three variables, from and to zip code, size of the box LxWxD and weight. I ship a lot of saws and can...
Forgot one thing, after you get the puller on, pick the whole saw up by the flywheel a little off the bench an inch will do, before you hit it....
You can reach Bob @ 845-657-6395
You might also contact Spike60, Bob is both a Husqvarna and Jonsered dealer. Much closer to you than TL so ship will be less! The small mount...
Well the key to the tool is a hammer ........... but what you do is screw the puller into the flywheel, tighten it up with your fingers until it...
Oslo, given you are in MA and I in NY, I could get the 362 to you shipping included for the advertised price. I go along with the rest of the...
+1 Cory! and you can always throw a 7300 or 7900 top end on it. Or you could have Cory keep an eye out for a Solo 665 1mm stroked crank and all!...
+1 with what Rookie1 said! Be VERY CAREFUL with the above set up, VERY easy to break things with the pry bar. Here is the puller for $10, go get...
Oslo, have a look at the classifieds, I have a 62cc Husqvarna 362XP up there. However the 562 at 59.8cc is a SWEET saw and no messing with the...
Don't forget to glue the bearings into the crankcase. Because of the 'C4' fitment spec used by Dolmar on main bearings, the interference fit on...
So you have an HVA rifle? So do I, what is it chambered for? I have two other examples of scandinavian rifles Schultz&Larsen 7x61 S&H, and a...
Over there 'enough is too much', Chainsaw Repair and here are much better environments to learn and share.
OBTW as soon as all the major components/options are here I plan to post a picture of all the stuff laid out on a table in the shop so that you...
More parts arrived today: Walbro 12-1 Carb and Intale setup Walbro/Tillotsen RWJ-4-1 and intake components this is the carb used on the 365/72XT...
Well it is small enough that you could put it on the mantle and your family could enjoy it too!
How is the new reservation system going? Is your calendar out into early 2015 yet? Cheers KRL
And that is why I said a PM. I have been the same place as Mdavlee where that sort of stuff goes on!
Mech, see above the spacer was to regain stock timing also notice that he opted not to mess with the port timing.
Jon1270, what a beautiful little saw.
No chit, Red Rider. Change one little thing and everything goes out the window. Add to that different manufacturers measure compression height...
