Watched the video, not bad not bad at all! Couple suggestions 1. Put the cases in the oven with the gasket surface facing up, set them on some...
Stihl recommends putting a little Dirko or 1194 around the outer surface of the sealing ring where it meets the case prior to installation. I have...
Sorry guys I could not get them to give away any B/C combos! They wanted $95 each for 18 inch Oregon produced bar/chain. Waaaaay too much cash, go...
Price of each unit is $479.00+$26.83 shipping to me=$505.83 each unit+shipping to you, which will vary depending on your location.
All of the Solo 665 NOS saws are enroute and should be here this week, Monday next at the latest. If my list is correct, they are all spoken for...
A while back I tried to pull that dishwasher trick with my wife, it didn't work. 1. She was pizzed as all get out 2. The dishwasher detergent...
As stated earlier, not every saw on the planet benefits from a MM. The 7900 is one of them. Take out the screen and open up the factory outlet a...
Wait a few tanks till she breaks in, then you will get the full effect! They are very nimble for an 80cc saw! I am so glad that you are pleased!...
That messing about with a hot case is bad enough with the bearings, let alone trying to get the crank in both sides and keep the gasket where it...
Bryan did you run the 7900 today or sell it to Dexter? LOL!
I noticed that you have an electric oven, they get hotter and heat more evenly than a gas oven, so I'm not surprized. The bearings need to be at...
200°C is around 392°F! What happens is that doing bearings on the crank you will end up with the bearings not where they belong in the case and...
'Bearings on the crank!' Nooooooooooooooo! do not do that RTFM, that is asking for trouble. The process is heat the case to 200°C tap the case on...
Here you go, PM a direct e-Mail and I will send the WM Assembly tool Assembling the crankshaft 502 50 30-23 Dismantling device Dismantling...
Try Spike60 if you are wanting one. I got two from him a month or so ago!
I saw the bearings in the case but thought you were R&Ring them. OBTW there is a Husqvarna tool that makes heating the case and freezing the crank...
Looks to be new main bearings, case in the oven and crank and new bearings in the freezer. I do that to my wife all the time, LOL! Also looks to...
OK guys here we go. Up today are the piston and cylinder choices for the custom saw. Poll runs 7 days!
Thanks Kevin, some of the firewood suppliers I do saws for have some HUGE guys working for them. Guys with hands like tennis rackets, smaller...
Mdavlee, I think you are right, a while back I checked out Madsen's and could find the Pro Safety stuff but did not see any thing for the 372.
