Great point Any time there is an over temp shut down there needs to be HUMAN SUPERVISION involved afterwards. On the little Whit once the snaps...
Pellet Stove 6" Round Gasket for Combustion/Exhaust Fan - 10 Pack 8581487496408 | eBay 7" Exhaust Gasket Whitfield Lennox Pellet Combustion Fan...
Welcome. Good to have ya...
Fall weather has returned...finally. We normally see about 3 inches of rain here in November, but up until Wednesday we had just .71" The rain...
If your exhaust fan looks like this piccy... These have ball bearings. Remove the 6 retaining nuts around the periphery of the motor (DO NOT...
All stoves can suffer this issue if the airflow is not correct. ASH Baffles filled up??? When the fire is correct it should have some light blue...
JUST AN FYI Always use some Never Seaze on the set screws on any of the fans....especially exhaust fans.
Sounds like you got it handled. A word to the wise on pellet stoves... CLEAN IS A GOOD THING. Ash accumulation is one thing that can cause...
Feasable ??? maybe....advisable, probably not. Getting sufficient clearance to make code could be tough
I agree about keeping the pipe hot and getting good rise in the flue gasses. If it were me, I would do a temporary connection to the clay liner...
The factory recommendations are certainly GREAT PLACE TO START. Buttttttttttttttttt, if this is an inspected install the inspector is going to...
I would see what your local regulations say and if they will allow it I would use a flange'd adapter to connect to the clay flue inlet and not...
I see your widdle buddy is helping
Use the moly type grease....its far less sticky, especially when cold. The moly grease also is not as likely to harden and dry out as some of the...
That bearing is very easy to find. Its a 608RS EBAY ITEM It's a common skateboard bearing Get ya a buttload of em cheap. Or go to your local...
That bearing is easily removed with a small bearing puller. To reinstall just be sure the shaft is clean an free of burs or nicks. Toss the fan...
Thanks troops. I will post a few pix when I get the little adapters done. I had a snap disc from a Quad... correct temperature and the size is...
The other morning we got up to a cold house and a stove not running...BUT THE SWITCHES WERE ALL SET AS THEY SHOULD HAVE BEEN. Looked at the...
Ahhhhh That could be an issue. We have a card lock (Been with them since 1991 when I started trucking) and their premium is the Alky free stuff....
The talk on using stabil or ??? in the fuel of stored equipment.... The best plan is to run the machine DRY and store it without fuel. Come fall...
