One time I had to excavate the line from the pump to the basement wall, I didn't have it buried quite deep enough. I just used an excavator I had...
Here, I have to cover all the well heads (here and rental properties) with a plastic 15 gallon drum with a heat lamp inside or they freeze up at...
Should probably add that my post concerning resetting the stove to factory defaults was right out of the USSC Tech manual that I have a copy of....
Mine don't. The switching is all in a hermetically sealed box.
In reality, on startup (cold stove) the feed rate starts at HR 1 and advances to whatever set point you enter on the keypad. All controlled via...
Interestingly, it's extremely cold here and I'm running in heat range 7 but I have my draft fan set on 2. No issue with excessive pellets / corn...
Actually.... - Reset to defaults -hold MODE and AUGER DELAY buttons for 3 seconds to reset all to defaults You must press them at the same time...
They still make contact type T'stats? Didn't know that. Even my cheap basic millivolt t'stats are electronic switched and the components are...
I always thought Ironwood (Osage Orange) was extremely slow growing, like an oak. I have a couple Kentucky Coffee Trees growing out back. Very...
Actually, I cut it with this and it ain't a lawnmower either...[ATTACH]
I never cut the grass, I bale and sell it, well I do around the house and the rentals but for the most part it's cut, raked, bailed and sold. Far...
and always will, no matter how hard humans attempt to alter it. I ought to know as I farm and Ms. nature dictates everything I do, every year.
I imagine that the majority of bio mass stove owners never bother to come on a site like this unless they are having issues beyond their scope of...
I'm sure there are. Things do fail however. His did. Far as the unit is concerned, I don't care for the multi piece burn pot at all. The...
Buddy of mine burned his out and I had to install some new ones and I used seamless schbedule 60 mandrel drawn tubing and it wasn't cheap and the...
My cousin fashion's long bows from them, Make a nice bow too. Stuff dried is harder than cheap steel.
Weather forecasters and politicians have a lot in common but especially one thing, they can lie but still be right. I it ain't snowing outside...
Look at 2 items carefully. See if there is any flame cutting above the forcing cone where the top strap meets the frame and if you can, inspect...
All that is in a thermodisc is a flat piece of round sheet metal that reacts to heat and 'warps' one way or the other. If I were you, I'd order a...
Some do, some don't (reset snap disc) If I was to replace mine, I'd go with the resettable ones. They cost a bit more but are worth it.
