:heidi:
2nd shot for me Wednesday.
Typically, millwork is mostly all softwood, so they should burn well.
NC just got 80,000 doses of the J&J vacc. yesterday.
:D
If you have access to a BFH, a hard metal surface (anvil, back of a sturdy vise, etc), and a flat-end punch about the same size, try compressing...
Vacuuming is good, but compressed air will do a better job if you have access to it. If you do, re-oil the bearing again afterwards.
Me too.....just got 1st shot yesterday. Drive-up site, waited about 5 minutes to get shot, then the required 15 min. after.
Me too. 7 business days from the time they accepted it.
This is what a lot of us use. About $30 on 'Zon [ATTACH]
Here are the "ports" you need to look for. Put 2-3 drops of 3 in 1 (Ideally in the blue can for electric motors, but standard will still work) in...
After removing the motor, did you look to see if there were oiling holes, and try oiling it? Might have saved it a while longer and kept the new...
The freezing rain threat here never happened......not that it was a big deal for me. If it DID happen, I just stay inside. Weather forecast for...
Hey jtakeman , they're on to you already. :bug:
X2!
X3!
Got mine in email from TurboTax this morning.
Try this. Goofy, but he really knows his stuff. "and there's your dinner!" https://www.youtube.com/channel/UC2Cd9kKYXFakV7ChvU_rjKw
Too bad he isn't doing it when points are on the line.
Go Kyle L.
