Well crap... Seems I killed the thread again.. Anyone care to join in the bore-stroke-case volume brain storming session? Kevin?? I know you got...
By putting the spacer under the 7900 jug, you'll be doing more than just adding to the stroke... There will also be added crank case capacity and...
20-25 thou on any saw over 70cc is a rule of thumb.. Though I have a 9010 with .019 squish... I use it on the mill too... Runs great... :whistle:
You guys would cringe if you watched me take one off... :whistle: I should just make a tool...
If it's something you don't mind throwing the coin at, I see a new 562 ex pee in your future... Something you'll not regret...
Well crud.... It wasn't Joey or Jody was it?? I've seen 044 carbs on 026's, and a couple other odds and ends, but few people really mod these...
How does it perform with a brand new Oregon LGX chain on it? If all I had was one saw to do everything, I would hate to give up the 20" bar......
Since we're all in a sharing mood today, anyone do a carb swap on an 028 super with good luck?? If so, which one is a nice step up? I was...
Grabby is not a desirable characteristic to have on a chain.. Many could confuse agressive self feeding and grabby, but properly set rakers "all...
Go on and remove flywheel... Report back.. If he pulls it over and there's no slippage, it may not be your problem...
One of TRX's chains just showed up here at the shop today.. I believe he ground it on a Silvey square grinder with the "blue" wheel. I'm sure he...
Because it's the only way to use "The Force" while sharpening... :drunk: That, and it leaves a beautiful, burr free corner and edge... And round...
Check the pop off pressure of the needle in the carb... If it's loading up at idle, chances are the spring pressure is too light, or the metering...
Pete, I got back a little late to the shop the other night, and I heard something calling to me from the top of my tool chest... It was my dad's...
Good question... I don't know...
They sure are huge open ports eh? Tripple's at that... Might be some to gain by just rounding the corners and reducing the overall volume... But...
The performance of the 84's have been a bit of a let down compared to OEM 7900... Not surprising though... Crank case is just too tight and...
I always wanted to get some epoxy and see what could be done with the OP 65cc jug...
The SS handles Hedge pretty well.. [media] Don't know what the new kid on the block is made of though..
You bought another saw, didn't you Dex... :whistle:
