I'm afraid I won't cast a happy tone on this subject. My wife and I have been through 3 or 4 mattresses in the last 10 years. I sleep like a log...
I'm the one on the right.
Having a small buck plate is a safety thing - if it were larger it could split wood that's not loaded straight and it would shoot free.
Ouch. Do be careful. You might split 50 pieces that give nice and easy and the 51st is the one that will burst.
I'm going to put new crank seals in it and see what happens. I hadn't noticed this before, but the screws for the oil pump are tapped right...
Do you guys feel it's worth trying to get a brand name engine - Subaru, Honda, etc? Those options always seem so much more expensive though.
How close are you to Elizabethtown? I have some rounds that will slow you down
... it all depends upon your appetite ... Good stuff. Mostly nice straight grain too. My white oak is snarly and tough.
I saw that today and now i'm thinking about how to make a frame that holds my Fiskars hatchet blade-up to do the same thing.
Noodles everywhere! [IMG] Looks like fun
Here's what I ended up with: a bottlecap from a Stihl 1gal premix bottle and my 20mm Craftsman short socket. If I lined up the cap just right it...
I've been doing tree service wood for the past year. The pros: some can deliver it to you, if your drop-off location is faster/more convenient...
I did the other side of the carb and it won't hold any pressure for even a moment. I could see/hear fuel blowing out on the e-clip side of the...
I'm trying to pressure/vac test my 365/372 XP XT. I have the exhaust side gasketed off with rubber/cork sheet. I wanted to do the same between...
I like mine. Simple, effective. If I didn't have a chain grinder I'd have a couple more.
Think I ought to bolt it together without base gasket and see if it's ok to go? The old parts with stock. 020 gasket measured .041 just now. I...
It has some scoring. I changed bearings and seals this winter and it was iffy whether to re-use it. Now I'd like to sell it so I'm freshening it up.
I've heard the like new compression is a bit low on this model. It's not a big deal I guess to run it for a while and increase it later, just pull...
I have a new jug on the way to freshen up my 372XP XTorq. I do not want a louder saw so I'm leaving the muffler alone. But I'm reading about...
Just eyeballing it, I'm thinking 1/4 cord stacked tight, which should be around 1000lb.
