No smart phone here,just cheep tracfone,but,if available in your area I recommend subscribing to NIXLE.
Facepalm
OK,from what I can tell,this young gal injured herself,while doing benefit work.I posed it before,and am doing it again.My SS check/payment came...
Best of luck!!!!
Gee,Snowy,you get all the inside work,and I am stuck up here without a garage,so jelly.But,your work is so very nice.
Laid in the snow,swapped out one of the fuel tanks on plow truck(79 k20),rusty mess.But,was 45,60% sun,and zero wind,a great day to do...
What an excellent pictorial tutorial!You are awesome!
Any stains can be cause for ---:heidi:
You can try doing a board "reset" by removing power from the furnace for 10 minutes.If that does not work,I would suspect a exhaust probe or...
The bearing replacement in your motor should be very simulacra to this--- [MEDIA]
Coffee time! :coffee:
My Accentra loves to be fondled,and that is with graphite and quality pellets,very little fines.My Integra,not so much.Years ago,a neighbors...
OK,2 things,after a period of time,even though I am still online,this site logs me out,I have to resign in.2I still have not found out how to buy...
So,yesterday early,had to go over the ridge and plow snow for the rich people,mostly just drifts,because of 60mph winds.They(both houses/families)...
Your cat could be my cats twin,lol
LOL great minds think alike!They were the only place I found(pellethead) that knew about the differences in the older units,I just ordered a...
There was also some of those stoves that made noise on startup,and was blower wheel hitting a piece of sheet metal.
You only replaced the bearing on the end of the wheel?The motor looks like a Ebm Papst,which also has replaceable bearings.
I believe his blower is a EBM PAPST,and the bearings are difficult to get to.Probably should check the terminal where the blower pugs into the...
