2 styles either extruded or Pressed in to block form. In the case of the extruded the friction from compression and extrusion causes enough heat...
Quincey's are excellant compressors. I have 2 at present 7.5cfm/60 gal and 15cfm/80gal In 25 years I have had 2 repairs between them. Couple...
Never ever go anywhere near the shoot, auger or impeller with the engine running, even with the engine off there could be built up tension enough...
impeller shear pin, then clutch belt arrangement- spring on the tensioner for the belt. I have had the bearing go south on the tension sheave-...
Most of the bent/ deformed loops I see are from the ground guys de-limbing and such so 14-20" bars. Sometimes the big bar chains are burred up on...
Between Murphy and the EPA fuel I can't win. Big blower( 36" 15hp) started leaking fuel from carb, then something locked up started burning belts-...
Murphy visited my place last Sunday. 36" blower walk behind 15hp. 5 passes and the smoke started appearing from the drive belt housing area. It...
Take chain hold it up stretched out and sight down it, might have to do this a few times to find the deviation. In some cases, if the things are...
little story with 20ga. regional match, no rear sight ( after all it is a fowling piece), but you can have a post or bead up front. 25 yard...
Built one years ago used it for match work and trap. sold most of the black powder stuff a few years ago. What is the question -if I can get my...
Minute of White Tail.
I have had the main 4 gauge wire to the starter corrode ( at the starter) to point it would not carry current. Naturally it died out in the...
If the case is being rotated as you say - perfect. There have been .are some autmatic anealing uniys - but the price:hair:
Neat nice job - suggestion 2 flames opposite sides
some of those persons make some stuff that might as well be lighter fluid for consumption in the shack :faint:
Look at units with some sort of shroud/ suppressor built in- Back yard friendly. Coons are tough. Even with a powder burner .22 rf, unless you...
yeawell we all surrvived- likely with a better education about less than adequate decisions. And then again........
ah memories, and to think I am still here.By current standards I should be dead and buried many times over. Guess I am just too ornery. Much more...
or new bar & shorten chains if still good and have the tools for that.
need to added drying agent to it to shorten time
