I keep a couple of 1 1/4" pipes to lay on the ground for rolling rounds onto the foot. I now have a winch to lift them on the bed. It is slower...
I am going to try, if I can get the weekend off.
Aluminum can be tig welded successfully with dc current, the gas has to be 100% helium.
Get her running. Check rubber lines and fill it with 40:1 and enjoy.
I believe that you know my evil twin.
Your memory is slipping.
Still sharp, I read it on the internet, so it must be true.
Did you cut your hand when you set that down Joe?
Termitebuffett and Huskihl both build a strong saw, both are good guys and honest.
A woods port job these days consists of cutting the base, setting the squish then doing the ports. Kinda tough to do without a lathe.
New, used? 50cc in your choice of colors.
Replace the fuel line. I will bet it has a hole in it, when the fuel covers it all is good @ 1/3 of a tank it sucks air.
What size are those shanks?
Husky recommends a 20" max bar. Husqvarna Chainsaws 545
Just about the perfect firewood saw, weight of a 60cc and the hindend of a 70cc.
Aluminum does in fact "rust" aluminum oxide melts @ 3650° and aluminum melts @ 1200° if you do not remove it and TRY and weld it you are in for a...
With a flame temperature in air of roughly 3450°F, propane burns cooler than propylene. This can be a weakness or a strength, depending on the...
There is no such thing as MAPP gas anymore, the map/pro yellow is polypropylene and is hotter than propane but not as much as acetylene. I don't...
Depending on tip size, I use 5 psi on acetylene and anywhere from 5 psi O2 (welding/brazing/heating) to 40 psi for cutting. The gas suppliers do...
I use 5 psi on both. Don't remove all of the flux just most of it.
