In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

Search Results

Search Again
Page 7 of 10
  1. Fifelaker
    Post

    Winter shutter reminder and question

    None of my saws have them and I have cut in below zero temps many, many times and never had an issue. I will tune the saw after it gets to...
    Post by: Fifelaker, Dec 26, 2018 in forum: Chainsaws and Power Equipment
  2. Fifelaker
    Post

    Thinkin' about

    I have several Forester bars (Green printing) that have held up well. Better than the last Oregon I had. I do not know if they offer a NK setup...
    Post by: Fifelaker, Dec 4, 2018 in forum: Chainsaws and Power Equipment
  3. Fifelaker
    Post

    Solsticefest 2017

    Bump!!!
    Post by: Fifelaker, Dec 2, 2018 in forum: Bulletin Board
  4. Fifelaker
    Post

    Chain for ms362cm

    I used Stihl RS chain until the price went stupid. I now use Oregon LGX, the stihl chain have more durability but not twice as much as the price...
    Post by: Fifelaker, Nov 25, 2018 in forum: Chainsaws and Power Equipment
  5. Fifelaker
    Post

    New backup saw MS 180 or MS250

    As far as the "home owner" line of saws go, my vote goes to Echo. They are built every bit as good if not better than the others for less money. I...
    Post by: Fifelaker, Nov 17, 2018 in forum: Chainsaws and Power Equipment
  6. Fifelaker
    Post

    Octane Factor in Saws

    Mdavlee ran the numbers on some ported saws a few years ago, he came up around 8:1-8.5:1 compression ratios on them iircc. My saws run better on...
    Post by: Fifelaker, Nov 16, 2018 in forum: Chainsaws and Power Equipment
  7. Fifelaker
    Post

    Bar and Chain Oil

    I use the Menards oil also. In the last few years I have went through at least 20 gallons and no failures yet.I have a Forester bar on an 026 that...
    Post by: Fifelaker, Nov 7, 2018 in forum: Chainsaws and Power Equipment
  8. Fifelaker
    Post

    non foaming oil

    I'm with Kevin, that's all I use.
    Post by: Fifelaker, Nov 1, 2018 in forum: Chainsaws and Power Equipment
  9. Fifelaker
    Post

    Water heater leaking

    I was told by the Rheem rep that the difference between the 6-9 and 12 year warranty's is the 6 is un-lined the 9 and 12 years are coated and...
    Post by: Fifelaker, Oct 31, 2018 in forum: The DIY Room
  10. Fifelaker
    Post

    Water heater leaking

    Looking at your pictures that would be an easy job to replace. Cpvc is easy to work with (it does take a different glue) Cut and move it to where...
    Post by: Fifelaker, Oct 31, 2018 in forum: The DIY Room
  11. Fifelaker
    Post

    Weight testing oak

    Two in the front and center the rear one.
    Post by: Fifelaker, Oct 26, 2018 in forum: The Wood Pile
  12. Fifelaker
    Post

    Weight testing oak

    The tail will wag the dog when you have less than 10% or less of the load on the tongue. How much was in the trailer and what did the tongue weigh?
    Post by: Fifelaker, Oct 25, 2018 in forum: The Wood Pile
  13. Fifelaker
    Post

    Tongs or log lift?

    [ATTACH] [ATTACH]I built this a couple of years ago, when skidding I have a shive that hooks low, so instead of tipping it is a straight pull. I...
    Post by: Fifelaker, Sep 28, 2018 in forum: Chainsaws and Power Equipment
  14. Fifelaker
    Post

    Ms261 mtron w/ 3/8 chain?

    I have a ported 026, I ran a 3/8 7T on it for a short while and quickly went back to.325 8T. I had to be more gentle with the 3/8 where I could...
    Post by: Fifelaker, Sep 18, 2018 in forum: Chainsaws and Power Equipment
  15. Fifelaker
    Post

    Stihl 026 fuel problem

    There are actually 3 different fuel lines, one is NLA. It is on the early 026's iirc. it has a smaller grommet, I have had to drill the hole in 2...
    Post by: Fifelaker, Sep 14, 2018 in forum: Chainsaws and Power Equipment
  16. Fifelaker
    Post

    Cleaning up a red oak

    My wife says that I am half fast, at least I think that is what she is saying.
    Post by: Fifelaker, Aug 29, 2018 in forum: The Wood Pile
  17. Fifelaker
    Post

    Cleaning up a red oak

    huskihl builds a strong saw too.
    Post by: Fifelaker, Aug 29, 2018 in forum: The Wood Pile
  18. Fifelaker
    Post

    Cleaning up a red oak

    Mastermind saw works, Jamestown Tn. I have heard that Randy is only doing new saws now (just a rumor) He is on OPE more than here
    Post by: Fifelaker, Aug 29, 2018 in forum: The Wood Pile
  19. Fifelaker
    Post

    Looking to buy a new saw.

    The only answer is a 461/2 whatever it is now.
    Post by: Fifelaker, Aug 23, 2018 in forum: Chainsaws and Power Equipment
  20. Fifelaker
    Post

    #2

    Is he going to have pants on under the chaps?
    Post by: Fifelaker, Aug 23, 2018 in forum: The Wood Pile
Showing results 121 to 140 of 181 Next >
Search Again
Page 7 of 10