I ended up noodling up some of the elm, just because I knew it wouldn't burn very good in the brush pile we made, since it was of fair sized...
I have noodled quite a bit. I must say, I don't mind noodling. I only split by hand, so if it's difficult, I noodle, no matter what the species....
I have been wondering about the same thing.
Interesting, good to know.
Thanks for that tip. It stands to reason that different brands might be different, alright.
Is the Tecomec considered to be of good quality, compared to other options?
Thanks for the info. I have used chain breakers, etc on other types of roller chain, but never chainsaw chain, of course we used masterlinks or...
Yes, good point. I am pretty good at sharpening a chain, at this point. And I always do the rakers after every sharpening, to keep them at the...
Maybe I am ok on the 461 and 32" bar. I ran a tank of fuel through it, today, and used nearly a tank of bar oil, and the chain looks wet. I...
Yep, I am only running the standard 7 pin that came on the saw, but the bar is of course not a Stihl, it's a Tsumura, but still calls for the 105...
Yep, bar profile could make a difference. It seem like the bar manufacturer would take that into account, when designating the DL on the bar. But...
I mentioned in a different thread, that I purchased a new Tsumura 32" lightweight bar for my 461. 32" bars normally take 105 drive links and this...
Yes, I believe I have it on max now, so will just leave it that way, until I determine if I need to increase oil flow with new parts or mods for sure.
Your right, I don't think I have my 462 set on max, I had to back it off a little bit. I think maybe my 461 is oiling enough, maybe. However, I...
Thanks, fellows. Maybe I will cut and noodle some of it up, and see how it burns in a couple of years.
Thanks guys, for helping to clear that up.
Thanks, will that same piston and bolt work in the 362 and the 462?
Thanks, I may need to join that site so I blow up those pictures a little bit. But I read it, and get the idea.
So, looking at your picture of the pump set on max, if I just turn the slot for the screwdriver cross wise at a 90 degree the length of the saw,...
You're right! I went and looked again. What I thought was the pin, was the stop shoulder as best I can tell trying to shine a light and look...
