Ok boys here ya go. This is saw#2 in the build thread. I know ya got a cliff note version so don't be afraid to ask question. This saw has had...
I'm going to sell saw #2 and then as saw 1 breaks in a little bit I will play with the timing. :).
I got quite a bit of rum time on these saws sun cutting wood. More on this saw than #2. Both great runners. The biggest thing you notice on saw #1...
Last but not least change I raised the lower trans .040 over stock or .020 more over saw #2. It's hard to tell but the case entrances are very...
On the intake. When I do the next saw this is one area I want to do some more playing. Instead of lowering it on the next saw I will cut the...
Next let's talk intake. On this as well I just made it larger. It is right at 70% as well along with a little less dome on top and straighter...
Let's finish this up boys. These saws are down I like saw #1 the best after reporting it and I only made a couple small changes in it. Lets start...
I need a 390xp cylinder. If you have a good one you would like to sell give me a holar. Thank you!
Expensive! What ever do you mean! :whistle:
Well I'm not sure where your from but if your from SE IA you can't be to far away from me. Lol. And your more than welcome to come play anytime...
Yes sir. I cut the base and the squish. I took .020 off the base and .015 outta the squish band to yield .018 squish. Factory squish is .023. This...
And your correct on price. This one ported will run you around the cost of a 362cm stock. :)
Awesome. I think it will handle a 24" bar rather well. While my recipe is geared more towards the 20" bar. When complete it would not be hard to...
I know right. Wasn't for sure if they were interested in this saw. So if they show interest than I can easily make this a full build thread. Lol.
Now I will tear saw 1 back down and look for any little gains I can find. Little tweaks! :dex:
And here is saw #2. This is the one I showed ya the port work on. It's definatly stronger than saw .#1. And it has a timing advance of 5 degrees....
Ok remember these saws a re brand new so they will run even better once broke in. This vid is a stock saw vs my first conservative attempt at...
Like I said this is the cliff note version. Feel free to fire away with any questions and I'll try and answer them. If there's interest in this...
Next is the exhaust. I raised and widened it a lot too. It's at 102 now for a blowdown of 16°. This is one of the most pain in the azz exhaust I...
Next are the trans. Nothing fancy here other than they have been raised a lot. Saw #2 sits a 118°. And the lower part of the trans I raised .020 I...
