Like I said it's more impressive with a smaller bar,better chain and more 50cc saw range wood. I actually don't mine using it now. Lol.
[MEDIA] Muffler modded cs-500p vs ported! Enjoy
Ok I wanna say a few things before I post the vid. I ran well one of these for most of the morning. In the vid I'm using the stock 20" bar and...
This saw I just did was a factory demo saw and they said it had roughly 6 tanks of fuel threw it. Which I'm sure was a lot of idle show off time. Lol.
Idk. When a customer sends me one. Lol. When I got the new saw in i was intrigued. A 50cc saw back in the 10 lb range. Well I tore it apart see...
I'm anxious too. I still imagine there's alot more than what I gave this first saw but we will see what we get. IMO this saw needs about 50%...
Final pic for tonight. After about 5 min run time and then letting the saw cool. Here's where my comp landed. [ATTACH]
All that said she is back together and I've put about 5 mind run time on it. I'm hoping tomorrow I can get some cut time comparisons in but we...
So pretty simple as this is what she looks like now. [ATTACH]
On the muffler. I'm sorry I forgot stock pics but it's pretty simple for the first go. This little pipe is bolted on by the deflector. So I took...
Last but not least the exhaust. Now I raised this to 110°. As a rule of thumb I take a 50cc saw to 105. However I've already raised this one from...
Pic of the final trans. Again I'm not super happy with how they look but only so much I could do with the transfer inserts. They will still fully...
I bet I have 5 hours in these trans alone. They are not fun. Period. And while these are the prettiest work I've done. I think they will function...
Next are the trans. These trans are a mother f***er. I set them at 125. Why. Well they have 11° blowdown stock. I've noticed on several other...
At first I thought about epoxing this intake. However it has a really small carb and intake tract. Kind of like an 036 stihl. And an 036 likes...
Pic of the roughed in intake. I widened it to 55% notice how I angled the top corners down to allow plenty of room away from my ring end. Now the...
Here's where the intake sets at bdc. Pay close attention to the lower ring end location. [ATTACH]
First thing I did was cut .030 from the base. Now on this saw like I said it has a dome piston so in this case I cut the sq[ATTACH] uish band at a...
All right boys in do have the first saw done but havnt got to sink it in the wood yet. That said I would like to hear your guys thoughts and...
[ATTACH][ATTACH][ATTACH]
