for reliability, make sure it has the metal intake clamp, not the plastic snap version. Also some of these had the auto decomp valve. If so, plug...
Another easy one is to make sure the kill switch wire is still on the switch and not laying on the floor of the carb box
I’ve used the cord a lot in the past. If you’re going to work on lots of saws, having a nylon/plastic stop is the way to go. HL supply has them....
I’d pull the loose ones out, one at a time, loctite and re install just snug to a little more than snug. Then pull the back two, one at a time and...
My favorite stock saw! Mark I did have the off idle bog issue that was fixed by the change to the AT-12 carb. I think it was the AT-7 that had...
Aunt Carrie’s Corner table, lobster roll and a Gansett Point Judith RI
Take 5 minutes with a T27, screw driver, scrench, hex, etc and give everything a check for tightness. I’d suspect muffler too.
Checkout the AV also. Those are soft have seen them degraded. check AV’s too. Soft and degraded. I’ve had unexpected throttle movement because...
not necessarily Aside from gasket and diaphragm, replace the needle, pull welsh plugs and clean all ports as best you can with carb cleaner and...
Same condition, XP.
[ATTACH]
[ATTACH] Likely first domino
Husqvarna 350 Air Leaks Decomp Valve and Seals https://youtube.com/shorts/lCWk_YSQH60?feature=share
1
Bump! Happy Mothers Day!
i saw one on CL in VT for $50 last weekend Looked great shape. Would have been a steal! I was too late
[ATTACH] [ATTACH] Been ready to hang the second set of doors for a while. Probably lose up shop this weekend. After pulling the jewel weed.
[ATTACH] From the second slowest build ever, 357XP got a new piston this afternoon.
you do nice job on the body clean up What is that you used to get over shoulder so the seal didn’t roll? I like the window on pasta boxes. Real...
