Schumacher has lost me, unless I've missed something on their website all they have now "fully automatic" crap. That's what my "new" charger is...
Unlike my big heavy modern charger, this one even has a handle on it to pick it up! Who knew? There was a sibling to this one that was 2-10A but...
FINALLY! Snagged from my hardware store (the dump) scrap pile, old school battery charger without a microprocessor. Couple hours of enjoyable...
Love my Echo equipment, the only small engine stuff I buy now.
Think I've finally got something resembling a grip on the 6ARC project. Almost a month had passed before I had a chance to run 30 rounds I loaded...
Brought it back to where I got it at the dump with a note outlining everything I'd replaced, what I had done and how it was acting, followed by...
[ATTACH]
Well I'm calling it. Got it running with the same weak results. Sprayed around with wd40 while it was still cold looking for leaks and noticed...
Yeah I got a drawer full of off brand chinesium plugs for dire emergency, but I don't use them. If I had my druthers I'd get NGK but the hardware...
Not entirely sure it was worth it (yet) but I've gone this far so, ...yeah... Maybe, if I'm not too disgusted I'll check the coil gap again...
That possibility was taken care of way back and it works fine in the weed whackers. I use gas from (2) 5gal jugs to feed everything, no problems...
Still thoroughly confused. Put a seal kit in, crank seal, cyl base, backplate, carb seals, and same result, runs very very weakly and gets hot...
Checked the chrome inside the bore and it is in still place, if I had the specs I have snap gauges and Mics but since the plating is so thin to...
I suppose a pressure test would help in locating leaks, but I've never found these inexpensive consumer grade engines to hold much in the way of...
I don't have the means to do V/P test, and there is only one crank seal besides the backplate O ring. It's in pieces in a box at the moment...
Still thoroughly confused... Put the new ring in, new carb showed up early so why not, new coil, new plug. Coil .010 spark plug .025 Cylinder...
Speaking of USA made, my "new" Beretta 92X RDO was made in Tennessee, not Italy. I say "new" because I bought it a year ago and only this summer...
Longer ago than I care to think, I was deeply immersed in the R/C airplane world. That included some rather large models, one of which I bought a...
Yep... they'll make it as good or poorly as they get paid to. With of course their own government restrictions of what tech they allow out.
Last I knew, Redmax used Zenoah engines which is (was?) a subsidiary of Komatsu and made in Japan. Subject to change of course.
