Sometimes things happen for a reason. Can’t argue with devine intervention. Daughter was due May 11 so I wasn’t too concerned but her water broke...
Little spoon
Seems like that kangaroo on the box should be humping a panda or sumptin.
Oregon used to be a popular high-quality manufacturer when it produced their bars in the US and Canada. I don’t know the details of it but many of...
Lol:thumbs:
Can’t make it, Adam. I’m sorry about that. The well at deer camp took a sh!t and the guys are planning on a few weekends back to back to get it...
This rig right here GENUINE TILLOTSON CARBURETOR FOR STIHL 064 066 MS 660 HS-320a | eBay
Tillonson offers a reasonably inexpensive replacement carburetor for these as well. I believe it’s called a Tillotson exchange HS – 320. Don’t...
To add to my last post^ There is no set number of turns in or out for your idle speed (LA) screw. It goes where it goes to make the saw idle properly
Sounds like your carburetor is putting out too much fuel. Set the H and L screws at 1 turn out from lightly seated. Your LA screw is for idle...
This is an issue with them that most people don’t mention. By the time you replace the problematic parts; carburetor, oil pump, fuel/pulse lines,...
I see you’ve never removed the white plastic on the clutch side lol. They are usually full of deer pellets bouncing around after a couple years use
Joe does a good job as well
Every saw has them underneath protected areas. Oily sawdust vibrating around
Depends on where it grows. I believe it’s from certain minerals in the ground
That’s a red Elm.
I would get a snowblower for it so you can put all your snow in your neighbor’s pool. Legend :yes:
Thank you all. Had the kids and grands over this afternoon for dinner. Had a great day
Like mentioned, you need to bury enough of the tip to where it’s putting a load on the saw and make a continuous wide open cut for 2–3 minutes...
Don’t know. Only seen pics on the webz
