that was run for a day is why the cutter looks polished up ,here is a ground one [ATTACH] [ATTACH] [ATTACH]
No poison ivy around here ,not sure what it is
[ATTACH] For Hedge ,Left cutter by hand [ATTACH]
Hold the file roughly 45 degrees to the bar ,now tilt the file so the bottom of it is barely touching the tie strap ,when you line up the outer...
if i face the bar tip toward me ,can do the left cutters with right hand ,is that what you are calling back handed ? 2 hands like this works on...
Lh cutters still are not my favorite ,if i use my left hand seems to go better though
Here is a better one i did ,less chatter and was actually sharpening the chain [MEDIA]
bad one handed video ,was not doing much to the cutter ,but gives general idea how to file [MEDIA]
when you get your chain dialed in ,you will not tear the chips ,will be a clean cut on both sides ,took me a long time to figure it out ,take your...
hope this helps the wide part of the file does the top plate [ATTACH]
Make sure the crank seal on the oil pump bushing is not leaking,I have had a couple act like carb problems, I set the bearing on that side with a...
That is almost like looking at an old musclecar ,very nice .
You guys would cringe if saw how some guys around here store the saws ,they just leave them in the back of the pickup year round to get...
I like cookies ,i can split them with my x-7 just fine
That sloped back cut is kind of dangerous ,it will not keep the tree upright if it tips back if that is the thinking of it .make your back cut...
Chips ? here is a 12mm ms440 with a mahle 10mm jug ,stock porting ,32 inch bar in cedar ,the hopped up saws rev higher with the bar buried...
sounds pretty good
I thought the right thing to do was put new rings on my ks jug 10mm 044 when i had it apart ,well after a while i pulled the top off to try a diff...
i bet you get 170-175 comp ditching the gasket ,is that a 10mm miston ? i see the 10mm wings on the skirt . I would run that over the meteor 10mm...
Not that i am aware of yet ,they may drop the line if they have to retool for it ,20 year old saws are the minority anymore
