More expansion work at our plant.

They have the big base pad poured for the 2 silos now

 

The silos pad and end of building are completed
The calciner hearths are coming along fine. Only 3 more to lay and then the top

 

Last hearth is done, finish up the wall, and then the top.

 

Had a chance to check out the progress on the new calciner.
They have gotten the top bricks laid, now a poured mix goes over that ,even with toop of steel shell...hole in the middle is top of center shaft.
Getting gas and combustion air lines ran and hooked up to the burners

 

I can't even imagine what that cost to build these days...

 

Me either. All that stainless...
Keep buying that good paint...Sherwin Williams, Benjamin Moore, Glidden, Ace Royal, PPG...

 

Got a chance to check on progress of kiln build.
Big damper to control pressure and combustion gases. Also see the casting inside big pipe.
The top mix has been poured
A good view of the center shaft with arms and rakes attached. Note the openings, top hearth clay falls through center, bottom hearth clay falls through the outside holes. That's the way clay moves through the kiln.
Arms with insulation applied...

 

The tanks came in for the pad in post #142 above. They got them installed Monday and Tuesday.
Big boy crane is backing in to set up...
Backing the trailer in with tank. Rear steering sure makes it easier
Smaller crane picks up the bottom end...
I noticed the front of the crane moving a bit...Wonder if he had any pucker factor going on...I zoomed in on the front outrigger pad...
Trailer gone, now time to start standing it up...
After taking the bottom braces and lifting plates off, time to lift it up and over to the pad...
On the pad, can just see it behind the concrete silo.
Sure didn't look that tall on the trailer, but it's up there...
Another good built product. Hauled over 1100 miles from WI to GA...

 

T.Jeff Veal Where in WI is that tank made?

 

Looks like Rothschild, WI

 

I have driven past that town a number of times when I was still working. I usually had to go to Wausau when I passed Rothschild.

 

Well, guess they just changed the tag. Different tank, same company.
Wausau...