Whoops...

I don't think my rear tire is supposed to look like this...
Only 291K on the original equipment and I wouldn't pull a heavy load......
Our pastor and I got bearings and seals changed in both sides Memorial Day.
The fun part was the bolt/pin that holds the long spider gear pin in broke off...had us scratching our heads for awhile....

 

Water pump from inboard boat motor.

 

Ya, got mud in your tires?

 

Little extra grease where it ain't supposed to be...

 

Sorry trying to make a “my cousin Vinny joke” .

 

It's ok......I had forgotten about that movie...
I guess all that dust and grease make mud...lol...

 

ruh roh......

 

A blade didn't fly through that hole did it?

 

I have a twin spindle 3008 that keeps curling all 4 blades upward and they are OEM Bushhog brand blades. I can't figure out why. I'm not treating it any differently than any of my previous cutters.

 

Uhh...

 

Yup

 

Why does my saw vibrate??

 

Looks like it's time for some precision balance machining. Break a couple fins off the opposite side and that guy should walk away a happy customer.

 

I was wondering why I could not get a decent adjustment on my parking brake. Finally decided to tear it all apart...

 

Nothing to see here...move along...

 

Nothing there is THE problem. The rotors were sooooooo stuck! I heated and and beated. I used pb blaster. The only way to get them off was with a tool I fashioned from a fence post driver and two of my wife's oven mits secured with duct tape.