Need schooling on fancy saw bars

Got it today. Have a thread on it.

 

Thanks, just ordered a set from them

 

The bar's tracking number said Monday but it arrived today !!
I was spinning about 20 minutes later. balance is awesome !! It's hanging from the handle.
Fully fueled and oiled.
Thanks guys for the help, it is a fun saw now.

 

Looking great, brother. Have fun

 

Since I already had the 28" Tsumura bar, I asked the dealer if we could swap bars on the 461. Got 32" B/C no charge. My son said he wished he was big enough to run that saw...lol...

 

He looks big enough to me.

 

He probably is, he said the saw looks big compared to him. He might weigh 120# soaking wet...

 

He was just holding it that way to show decal.

 

Screwloose did you do a muffler mod to your saw yet? I found a dual port muffler for the 461 on eBay(customchainsawparts) I think for $20. It is opened up and sounds good.

Factory muffler New muffler

 

That's the place I bought the skidplate from. I saw that they offer a machined aluminum dual for the 661 with screw out screens. I dunno as I added 1 hole to mine and it really barks now. Mainly trying to get rid of heat as it's the hottest saw I've ever run. Someday I expect the brake handle will melt.

 

Summer/winter shutter in winter mode?

 

Looks good Screwloose Now you’ll see what all the fuss is about.

 

No it's in the summer spot. I think it's just me not used to a saw running so close to lean. Inside of the muffler was clean with heat colors, purple and straw. I did my initial testing on the 50:1 motomix fill from the dealer but I since have dumped it and filled it with my normal 40:1 E free/red armor mix. Only a couple of test cuts on that though.

 

Good move IMO!