Fahrenheit Technologies Endurance 50F Information

The high temperature copper silicone disappeared after I did a visual inspection during my warm weather cleaning
I think I'll try to braze it later and temporary use chimney cement in the meantime or let it as is

 

I guess its not so "high" temp!

 

does anyone here have a new 50f just wondering if they upgraded anything

 

just wondering what a bigger impeller does for u

 

More top end on air for fuel mix if you ever need it
My furnace is somewhat new if that matters

 

Well My stove is newer I guess,only a couple years old.I wanted to install the bigger impellar for level 5 burning in January with hardwood pellets,I am hoping for a better burn maybe a little more heat.

 

ok thx maybe something I need to look into I burn corn so maybe that would help it

 

well my 50f is 8yrs old just wondering if they updated anything on them

 

It's good you remembered Now tape a note on the furnace

 

I've had the auger time-out on me twice so far this season,Each time ,I clean all the pellets out of the hopper to see if there is something causing a jam...I find some
sawdust.I press the lid safety switch and the prime button and it works fine.Then I vac the Auger out,fill hopper,prime it and it starts back up and im in business.I
Also checked for play in the auger ,it had very little. Any Thoughts Gentleman? Is it time for a new auger motor?? Thanks in Advance!!

 

Do you sift your pellets? Everytime I switch pellets and run the hopper empty I vacuum and oil the brass coupling. Mine also leaves a buildup of fines underneath inside the cabinet.

 

Yes and no,First start of the season I clean hopper every week. Then I start vaccing them when it really starts to go though alot per day
Was thinking about getting the beefier auger motor,The Fahrenheit are rate at 150 inch lbs of stall torque,The Glean/Avery unit is 180.
I started Vaccing them as of the failure.

 

Just ordered some "Ultra Premium" White Pine Pellets for the polar vortex days I hope I get and extra 10* out of them. Im getting about 165* out of my hardwood pellets(Pro Pellet) on level five.

 

And My Auger just timed out again...I think I have got it figured out.Fan Limit switch is going to hell,Tied the high limit sensor wires together and shes running,I am hunting for a new fan control locally.... My Fahrenheit dealer is just this side of worthless,doesn't stock any parts except for the top plate.

 

You can get that part at any furnace shop!

 

Yes Sir,Found one at premier heating in Ludington. Got it installed and been working perfect since. The old unit was starting to melt where the hot wire connects on the fan control side. Side note,
them damm things are spendy!

 

having a bit of problem with corn 13.9 % runs good for 3-4 hrs then after pot change it starts piling corn up in middle of pot any suggestions as to what the problem is all gaskets seem good on door an ash pan. getting flustered

 

I'm mixing my corn(30%) with pellets(70%) so I can't tell you what gives. It might be sticking to the burn plates ? I find my exhaust screen gets a build up of soot, could be the fines in the corn which I manually screen prior to mixing with pellets. I need to find a way to vacuum the corn prior to loading my barrels. The bluejays are enjoying the crumbs

 

I have a new idea for a vac system,I will be building after the silly season.