Quadra Fire Contour - what are we missing?

Here's one at Earth Sense for $130 (if you have to buy one)..they're good place to buy from...I get a lot of parts from them.

QuadraFire Pellet Stove 3 Spd Control Box Circuit Board SRV7000-205, SRV7000-704 | eBay

 

One other thing to try is jumping Snap Disk #2 to try. Unplug stove first.

Snap disc #2 is also located on the right side of the stove, below snap disc #1. Two yellow wires are connected to it. This snap disc will bypass the thermostat and turn off the stove if an overheat condition occurs, or if the convection blower should fail to operate.

 

So, remove from #2 and jump the 2 yellow wires?

 

Correct....jump the two wires together.

 

You can take the board out again and give it a couple good whacks and see if it un-sticks the relay.

 

Still no light .....

 

Chit....

 

The only thing you can do on them is unplug and plug back in...

 

Here's the manual in case you don't have it:

https://downloads.hearthnhome.com/installManuals/250_5583.pdf

 

Tried this just now-no go! But having lots of fun! Next?

 

Have this! Just found a place that has a service and tech manual - maybe that will help?

 

Unfortunately, it "appears" to be the control box......unless there is a wire or something off somewhere.

 

I think you’re right. One thing we did notice is that the connection that the control board slides into, that blue seat is not secure. We’ll need to remove the back again to see what the deal is so will also check every connection when we do. Thanks much for all the help folks!

 

I have a spare board that came off a cb1200 insert that I could send him to try. Is this compatible with his stove

 

Good luck and let us know how you make out.

 

Yes it is!

 

It will need to be set on #4 setting for the Contour

 

Terry. I sent you a PM

 

Replied!