In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

What's the hole for in shorter Stihl bars?

Discussion in 'Chainsaws and Power Equipment' started by akennyd, Feb 28, 2017.

  1. akennyd

    akennyd

    Joined:
    Feb 15, 2017
    Messages:
    15
    Likes Received:
    65
    Location:
    NC
    OK, what's the hole near the end of the bar for on the smaller Stihl bars? I've done a little searching but have not come to a definite answer. Some say it was used for manufacturing the bar and some say it's for hanging/storage of the saw.

    I have noticed what some have mentioned that when plunge cutting, the hole at times can hold saw chips and bind up the blade.

    Thanks!
     
    akennyd, Feb 28, 2017
    #1 Top
    blacksmith likes this.
  2. Casper

    Casper

    Joined:
    Jan 25, 2017
    Messages:
    1,707
    Likes Received:
    9,648
    Location:
    Ohio
    I recently picked up a couple 192t's that have the hole. The slot at the mounting end is a through slot (not closed on the end) so I hang the 14" &12" bar from the hole.
     
    Casper, Feb 28, 2017
    #2 Top
    akennyd likes this.