In loving memory of Kenis D. Keathley 6/4/81 - 3/27/22 Loving father, husband, brother, friend and firewood hoarder Rest in peace, Dexterday

poulan 306a

Discussion in 'Chainsaws and Power Equipment' started by markr, Jan 2, 2015.

  1. markr

    markr

    Joined:
    Dec 8, 2014
    Messages:
    237
    Likes Received:
    890
    Location:
    ohio
    Got my usedpoulan 306a today. 120 psi runs with gas in carb. (Lines maybe carb rebuild etc.) No bar or chain. Got it as a back up and I like these old saws. Suggestions on bar and chain. 20 inch? What say you?
     
    markr, Jan 2, 2015
    #1 Top
    Chestnut likes this.
  2. Guido Salvage

    Guido Salvage

    Joined:
    Oct 5, 2013
    Messages:
    1,735
    Likes Received:
    4,938
    Location:
    The heart of the Bluegrass
    I have a number of 306 saws, at 59 cc's they will pull a 20" bar.
     
    Guido Salvage, Jan 3, 2015
    #2 Top
    HoneyFuzz and raybonz like this.
  3. DexterDay

    DexterDay Administrator

    Joined:
    Oct 2, 2013
    Messages:
    12,411
    Likes Received:
    31,632
    Location:
    Northeast Oh
    Friendly bump..

    I hope someone has the info you need.
     
    DexterDay, Jan 3, 2015
    #3 Top
  4. Mag Craft

    Mag Craft

    Joined:
    Dec 15, 2014
    Messages:
    4,802
    Likes Received:
    27,728
    Location:
    South East Wyoming
    I have a 306a and yes it will pull a 20" bar just fine. Also like you mentioned if it will start on prime but not run then I would do the fuel line, filter, and kit the carb. Like Guido mentioned 59cc and not a bad running saw.
    Just make sure that you are aware of it being an older saw and keep your ear tuned to the engine in case a crank seal is going bad.
     
    Mag Craft, Jan 4, 2015
    #4 Top
    DexterDay likes this.