Looking at a MS 361. Looks in brand new condition. Thought it was discontinued back in 2010? This a saw worth grabbing?
Great 60cc saw. I think you are right about when they were discontinued. I'd sure buy one for the right price.
Price is up there $700 But this thing is mint. It’s been sitting unused since he bought it. 18” bar with not a scratch on it and 22” bar still in the wrapper. Plus four new chains. Personally I find it hard to believe this thing runs but he says it runs great. Must’ve dumped the gas at least LOL Haven’t seen it in person. Internet haggling. Seeems fixed on the price.
Solid saw pre m Tronic I love mine has never failed me. I was almost stupid enough to sell mine when I bought my 362. Sent from my iPhone using Tapatalk
Ok folks. I do t know a lot about saws. Do I need it? Not really. Is the price too high? Probably. Just how crazy would I be to buy it? LOL
LOL it’s a good thing I don’t depend on you folk to spend my money. Forgot to ask for a squench tho. Gonna have to dig for an old one
Buy that sucker, its my go to saw for bucking. The thing screams thru the wood and its light. I have owned mine since 2004 ish and it still runs great. I have no idea how much wood i have cut with that saw, but its alot.
That looks very clean. I personally love my 361. I would let my wife repeat the gift of that saw knowing then what I know now. Depending on your level of use. That saw could last a guy the rest of his life.
Yeah I bought it. It’s a clean saw alright. Probably not even broken in. Give the owner credit, his attention to detail is way beyond mine. Type of guy that takes the entire saw apart after every use and polishes all the parts LOL Sticker under the muffler is still pristine. Fired right up. Gonna be cold tomorrow morning but I think I’m going cutting Thanks for the opinions folks. I wasnt the only one interested I hear. Had to jump.
Ports or parts One of these days I’d like to get a nice ported saw. Older friend of mine use to race 2 stroke drag bikes back in the 70’s 80’s. He did some radical stuff to those engines. Wish I’d of paid more attention.
lol jason polishes and like me depends on the porters to do their magic there are quite a few good ones around here and i have dealt with most of them as of right now i have about 15 ported saws and 4 more of mine being done now its a addiction
I understand and the addiction part. My last hobby was benchrest rifles. Eating Ramen noodles to feed my habit.
What kind of gains do you think you get from,,,let’s say,,,a woods port job? On the 361 for example. I actually bought that 510 Dolmar without any investigating on the chance I might take a dremel to it. After I got it I found it’s not the best candidate and there’s a lot more to engine work than gouging larger holes LOL
this a 036 kevin did not too long ago he also did a 361 and turned out good i have 4 saws by kevin right now a 10mm 044 , 461,064 and a 661 and no complaints on any of them
my stumpshot 361 chain was starting to get a little dull hit alot of dirt when we was cutting 20 inch bar 8 pin sprocket
