I'm trying to stay ahead of the building inspector.....if I nail anything to the top of a wood pile, say, tin roofing, the triggers his permit...
So this gets more dramatic, in a continuation of 2022: the year every thing goes wrong! Got the new damper in after a knuckle-busting,...
Put what ever is in reach in the woodpile without having to get dressed, in the stove. Grab MAPP gas torch Depress trigger....
I shouldn't have read this post....been running a buck 27000 for 11 years now. I'm at the point where my before-bed load is an olympic level, life...
I still haven't found anything detailing how to remove/install it. I can tell you, from redoing the stack gasket years ago, that the t-bolts are...
As to the local dealer, that's how they decide to operate. It's a local, non-chain hardware store and the 80 year old owner has never left the...
I like that answer! As for footing, I'm picky, and will walk away from anything that requires me to dance to get to or requires more cutting just...
I've been burned by Amazon fake stuff to many times, I won't even order water from them. Looking to replace the oiler and related...
Funny you mention pinching bars....big storm a few weeks ago.....lots of trees down. FD was cutting their way in (to a tree thru house/trapped...
I got an old old Buck 27000 stand-alone. The part where the damper connects to the damper rod just snapped, the round thingy that is (was) welded...
Not married to Stihl. Co-op sells and services husky (albeit a 6 month wait for service right now). Further clarification, 50" (DBH) isn't the...
I should have clarified: I can get through 30" oak with my 18 going at it from both sides. Don't really carry a tape measure, but I've gotten this...
"but not to heavy to limb with above shoulder level for a while." I like that feature!
Been using the MS-250 for 10 years now, bought it when the neighbors said "county don't clear the road" (when storms bring down trees) and they...
I use 5/4 (1X6) deck board, turned sideways, for my "roof loads". Sleepers parallel across them, then tin. Cheap as hell. I did 3 14X6 (ft)...
Having some direct experience with the process.......I'm surprised it's only 28k. Typically, the time (billed in 15 minute increment's) of every...
