Yeah its a bummer for sure. I have a vague memory of folks discussing using off the shelf control boards to power these things. Maybe buried...
Howdy all. Sorry if this has been discussed already, but with the recent shutdown of Fahrenheit (no longer providing parts), I'm wondering what...
My workaround was to keep the auger motor connected and measure voltage across it, rather than on an open circuit. That sufficiently bled the...
Thanks Ssyko, I agree about replacing the motor (just did it). I'm not sure I agree about the ghost voltage. I'm not an electrical engineer, but...
I sure appreciate that info Snowy. Separate fuses makes a lot of sense. You say a pellet stove is simple in essence; I agree they are simple in...
Yes, good call on the protector. Apparently these boards are made in New York. And they can be sent for diagnostics/repair, which the dealer is...
Well this has been a bit of a slow burn project, but I finally was able to spin the motor with a new board. Sail switch and everything else...
Can anyone tell me what the air-pump is for on the Endurance? The vacuum confirmation is via the sail switch, correct? No vacuum pressure switch....
The unit is from 2014. Using a Maine softwood pellet. Maine Woods Pellet The vacuum and POF switches are something I haven't really looked into....
Ahh more food for thought. You'll be able to tell I've not had much time troubleshooting this lately. Here's a pic of the over limit switch I was...
Thanks for that Ohm reading. That sounds pretty close to what I measured, but I'll double check. Interesting about the surge protection. We don't...
A little update. I confirmed that the motor, when hooked up, is not actually getting voltage (about 1v ac). The 120 voltage reading with open...
I should clarify that I didn't take the auger motor out of the stove to run it. I just cut a power chord and hooked it straight to the auger motor...
Thanks wildwest
Here's the wiring schematic for what it's worth: https://www.fahrenheittech.com/Fahrenheit_Manual.pdf (page 28)
Hi all, new here to the forum. Have read some threads and enjoyed the collection of knowledge here. I have a Napoleon NPI40 at home and an...