*pipe could be extended down and then capped as a sort of creosote trap (like sediment filter) or if water was a concern, but I just don’t see it...
Now, I prefer what I did for my basement install, but this works and was done by the stove shop in 2012. Notice the cleanout plug.
[ATTACH]
I think there’s something off with either your setup or our communication. The correct setup on through-the-wall Ts is the bracket, T, clean-out...
The cap should not be that heavy. The link you posted… is that what you have now?
Wait- is that length of pipe setup just putting pressure on the cap? The lock mechanism is the partial thread. You have to get it just right and...
Get the proper cap/plug asap. I see it’s Duravent so the 1/4 lock design. Each company has different designs for that. They’re available online...
* I have three in total. One Otter and two Pelican. You can use any type if you create a tow bar or reconfigure your setup like you’re doing with...
That might just work. On low snow years, those otter brand setups would get discounted as “used” on Amazon. The best part of their design is the...
They usually pull “okay” and within reason (unless the bolts are bad… but there’s ways around that). Going through it and seeing 30 years of...
I recommend the hyfax for anything that gets high use. I didn’t like the drilling concept either but having a sacrificial area that can be...
Oem ideally. Not sure if you have a 194 carb but those are desirable. Stens is okay. Cheapest aftermarket have some problems but usually work for...
These 1121s can be finicky. From pesky crank seals, tank vents, and carbs to air filter issues… but worth it when they’re dialed in. Use an NGK...
Yeah, tough to say. All oem fuel and impulse lines are needed. That red lever style tank vent can be modified in a similar fashion to what you...
Sweet! Gotta love those old machines. I have a 96 Polaris 488 trail and pulled the skid last March. Both (!) old hydraulic shocks were shot....
Determine where it’s leaking before going into the crank seals. They frequently hold pressure but fail vacuum. Double/triple check your setup for...
I shudder to think of how many of these blowers have been tossed out after a snapdisc, rheostat, or dirty bearing problem. I have one on my bench...
Better send the Wilder boys to get more grain from the miser outside of town… but yes, the cat issue is yet another reason why my frustration...
https://a.co/d/iNHCXJi This is the version I like. I have the cheaper ones, too.
I haven’t had much time recently but here’s a few things without closely reading all of the posts in the last year: 1. Like Stihl’s 044/440, that...
