3 months? I was there a week or so after my knee was replaced. You better be there, we need magnesium.
I should say in a 3003 mount it's 67dl. I just noticed it's 62 on the 3005.
16" takes 67dl in .325
A company I worked for had a 79' Mercedes straight truck, the manual sad you could run a 50/50 gas diesel ratio. I think that engine was a 1950's...
[ATTACH]
Butt that was 94cc"s
Warranty, shmoranty. I would not hesitate to hand Kevin a new saw. He may even find something the factory missed. It's doubtful I will ever buy a...
Will them digits fit in a 545?
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
I see posts on fb almost daily about bears. We have quite a few around here. I usually see 4-7 per year, I haven't seen any this year yet? I did...
I meant rotate the grinder. The crap off of the wheel goes straight back.
Can you can turn that 90°
As the chain warms up it stretches a bit, the longer the bar the more it will stretch. How does the sprocket look?
Mine did the same thing. Take the recoil off and clean and lube it.
Not as many BTU's in German cockroaches?
Pretty sure their chariots didn't weigh 80,000 lbs either.
I mix @ 32:1 start it warm it up and run it like I use it. I always used mix oil on assembly so I never mixed heavier than what I normally run.
Yup, bar size determines which saw to grab, A Husky 55 and a ported 026 up to about 14" a ported MS440 up to about 24" over that out comes the...
With an OWB that will take up to 32" and a splitter that will take up to 27", I cut what I can lift /split easily. I have a couple of stacks for...
And it's due any minute.