I caught the scale error after I posted draft readings. i'm checking at port in fire box and using plastic to seal around tubing of gauge. drafts...
had an older analog gauge for draft measurements which showed low draft, obtained newer digital gauge. draft reading about -.035 on high test...
all your assumptions are correct and are exactly my thought process. I haven't been able to find any info on logic or circuitry of control board....
cheapo surge protector. but new board exhibited identical problem immediately after installation, so for now i'm trusting the vendor
looking at schematic since the ignitor runs off the vac switch also and it lights pellets switch initially works. don't know if it could lose...
good point, the next time I pull it (its an insert, makes it tuff) i'll check hose, can't check while running
as stated above it starts fine, ignites fine and burns continuously. I need help with why the feed motor is only feeding (receiving power) 25 % of...
you're missing the point, the feed light is not coming on. when the feed light comes on (meaning electricity is sent to the motor) it feeds just...
test mode = all motors run seem to run normal it runs in the "limp" mode without shutting down had the slide plate out once and have inspected...
red esp replaced red esp dips checked and rechecked auger motor removed, auger spins freely and pellets feed when feed light is on problem started...
pellets are lignetics blend. stove starts fine, ignites fine, starts burning fine after 5-10 minutes stove works its way back to approx. 1/3 max...
