Yes, it is angle iron
Not sure what you mean. Where is the black edging you are referring to?
I checked and double checked everywhere that was suggested, siliconed every seam, replaced the fan, cleaned it thoroughly, took apart the pipes,...
Update - I installed the new fan, fired up the stove and still have a faint smell in the back of the stove but it is NOT smelling in the room and...
OK, I cleaned under the trivet. It had lots of black sooty stuff on it. Took multiple washings to make it clean. I will hold off on taking...
That is so true and words I live by, much to my children's dismay . . .
:hair: Let's hope!!!
Thank you all for sticking with me for 5 days on this! I am in wait mode now. New fan assembly should be here on Friday. I will report back...
I am working with don2222 to get pricing and delivery time. Right now I have a towel stuffed in the fan housing to keep the cold air out of my...
My manual says to oil it every 6 months or yearly depending on use with 30 weight SAE non detergent oil at the 2 lubrication points.
How do I pm him?
Great! Thanks! I will wait for suggestions for replacement motor/fan assemblies suggestions. One more question. I installed it with a vertical...
The fan is around 10 years old and since I never took it apart before and cleaned it, I am assuming it is shot so rather than waste my time...
This u-tube video talks about a "spin test". My fan blades stopped spinning in about 5 seconds when I tried this. According to this video, they...
I was hoping to test the fan before I reinstall it.
How many RPMs should I be looking for? My mechanic friend may be able to test this for me. Never mind, I found the sticker. 3000 RPM
OK, removed the fan, cleaned out in both directions. The repair guy had already cleaned the horizontal pipe run when he removed and cleaned the...
Also, I just siliconed the hell out of it. To remove the fan I would need to cut through all the silicone?
Once you get the exhaust van off snap a piccy or two of the fan housing and up into that rear passage...(Where the little damper plate slides)...
I am not sure what you are saying. Here is a picture. Can you tell me which bolts you want me to remove? Will I need a new gasket if I do this?...