For future reference if you’re looking for gasket CS1-9502 (that seals the combustion fan housing to the exhaust weldment), part number PP5202 is...
Is this it? Upgraded motor and blade? Fahrenheit 6 Inch High Quality Exhaust/Combustion Blower & 2 male clip | East Coast Hearth also looking...
Looking for information on the upgraded combustion motor and fan for the 50F. PN and/or source. Thanks!
What kind of temperature deltas are you guys seeing with your units, between intake and outlet temp.
The chart was from my pi40, I just started testing with the 50f and yes I believe I do. Sent from my iPhone using Tapatalk
Also, I am seeing about a 58F difference between inlet and outlet temperature on level 5. Does this sound right? Sent from my iPhone using Tapatalk
How long does your unit stay in “stabilizing” prior to running? Sent from my iPhone using Tapatalk
I use the numbers from each different pellet type to evaluate BTU vs cost delta between them and to compare to current propane prices.
On my PI40, it was all manual control so what i did was take the temperature delta between the inlet air and outlet air after 20 minutes of...
Do you guys monitor air return and outlet temps with different pellets? How long do you wait to record the temperature delta at each setting for...
Do you guys use a thermostat or manual mode? Sent from my iPhone using Tapatalk
The serial looks like 2667 or 2006, it’s stamped on the back plate near the bottom left. Seems a little steep for that age and the older model...
Do you set the butterfly valve on the air intake based on the flame at level 5? Sent from my iPhone using Tapatalk
Yes, I can get my hand in there and I have some of that permatex on hand. Thanks! Sent from my iPhone using Tapatalk
Hi All, I got the 4" stainless liner installed and the T put together at the bottom that extends out of the chimney. Now, at the vertical and...
Got the 4" stainless liner in and the T put together at the bottom that extends out of the chimney. Now, at the vertical and horizontal T...
Anyone familiar with the DuraVent pellet pro adjustable length pipe? I read it as the 12” pipe can adjust to an installed length of 15-24”??...
Got the 3" ID to 3" OD stainless adapter installed, provided plenty of room for the OAK!
Well hit a setback today during the install, found the chimney tile liner to have several cracks. Just got a new 4” stainless liner on order....
It appears to be a bit tight here.... Plan to get a 3" ID to 3"OD stainless adapter that will slide over the exhaust tube and allow me to push...
